ST Link V2 Mini STM8 STM32 Programmer

Description

ST Link V2 is an in circuit debugger and programmer for the STM8 and STM32 microcontroller families. The single wire interface module (SWIM) and JTAG/serial wire debugging (SWD) interfaces are used to communicate with any STM8 or STM32 microcontroller located on an application board.

STM8 applications use the USB full speed interface to communicate with the ST Visual
Develop (STVD) or ST Visual Program (STVP) software.

STM32 applications use the USB full speed interface to communicate with Atollic®, IAR™,
Keil® or TASKING integrated development environments

Features of ST Link V2 includes;

• It has an Onboard 500mA self recovery fuse to avoid harming by short circuit
• Has a Dual voltage output  of 3.3V to 5V
• In addition to that, It is easy for debugging/programming
• Also has a Standard USB interface for direct connection to PC

Debugging/Programming performance

• Debugging : run at full speed, single stepped, breakpoints, viewing variables and registers, etc.
• Programming : supports FLASH ROM, EEPROM, AFR, etc.
• USB 2.0 combined with SWIM/SWD interfaces : quick response for debugging & fast speed for programming

Upgradable firmware

• The firmware is upgradable to support more devices in the future
• Automatically upgraded

Supported software

• ST-LINK Utility v2.0 or higher ver.)
• STVD Version 4.2.1 (or higher ver.)
• STVP Version 3.2.3 (or higher ver.)
• IAR EWARM Revision v6.20 (or higher ver.)
• IAR EWSTM8 Revision v1.30 (or higher ver.)
• KEIL RVMDK Revision v4.21 (or higher ver.)
• ATOLLIC
• TASKING

Supported devices

• All the STM8 devices with SWIM interface
• All the STM32 devices with SWD interface

Datasheet