-
- Modules, Relays, Switches
4 Channel Relay Module 5 V 4 way relay
- KSh 450.00
- Features of 4 Channel Relay Module includes; It has a contact capacity of 250V 10A. Has an On board EL817 photoelectric coupler with photoelectric isolating anti interference ability strong Also has a Long life absorb 100000 times in a row Has a diode current protection and short response time Last but not least, It has a Maximum output of DC…
- Add to cart
-
- Modules, Relays, Switches
8 Channel Relay Module 5 V 8 way relay
- KSh 800.00
- Features of 8 Channel Relay Module includes; It has a contact capacity of 250V 10A. Has an On board EL817 photoelectric coupler with photoelectric isolating anti interference ability strong Also has a Long life absorb 100000 times in a row Has a diode current protection and short response time Last but not least, It has a Maximum output of DC…
- Add to cart
-
- Arduino, Modules, Sensors
GY-521 MPU6050 3 Axis Acceleration Gyroscope
- KSh 400.00
- GY-521 MPU6050 Gyroscope sensor module has an accelerometer and a gyro in a single chip. The sensor uses the I2C-bus to interface with the Arduino.
- Add to cart
-
- Arduino, Modules
HC05 Bluetooth Transceiver Module for Arduino
- KSh 1,000.00
- Specifications of HC05 Bluetooth Transceiver Module includes; It is a Serial Bluetooth module for Arduino and other microcontrollers Has an Operating Voltage of 4V to 6V (Typically +5V) It has an Operating Current of 30mA Its Range is <100m In addition to that, it Works with Serial communication (USART) and is TTL compatible Also Follows IEEE 802.15.1 standardized protocol To add…
- Add to cart
-
- Out of Stock
- Distance Sensors, Modules, Sensors
IR Sensor Module Infrared Obstacle Avoidance Sensor
- KSh 400.00
- The IR sensor module consists mainly of the IR Transmitter and Receiver, Opamp, Variable Resistor (Trimmer pot), output LED in brief.
- Read more
-
-
- Sensors
KY-033 Path Tracing Sensor Module
- KSh 150.00
- Specification of KY-033 Path Tracing Sensor It has a Working voltage of DC 3.3V to 5V Has a Working current of ≥ 20mA It has an Operating temperature of between -10℃ to +50℃ In addition, it has a Detection distance of 2 to 40cm Output signal: TTL level (low level there is an obstacle, no obstacle high) Adjustment: adjust multi-turn…
- Add to cart
-
- Arduino, Modules
Sensor Shield expansion board for arduino
- KSh 500.00
- Features; Ad hoc IIC interface Has a stack design Both analog and digital Interface It has a Servo Controller Interface The sensor has a Bluetooth Module A communication interface SD card module interface module Also has an APC220 RF Module interface Moreover, it has an ultrasonic sensors Interface Lastly, has a 12864 LCD Serial interface
- Add to cart
-
- Out of Stock
- Displays, Modules
Serial I2C module for the Liquid crystal displays (LCDs
- KSh 200.00
- Read more
-
-
- Modules, Sensors, Vibration sensor
SW-420 Vibration Sensor Module for Arduino
- KSh 150.00
- Features of SW-420 Vibration Sensor Module Has a working voltage of between 3.3 V to 5 V It has a Digital switch output 0 and 1 Also Equipped with fixed bolt hole. Therefore, has a convenient installation Moreover, has a PCB size of 3.2 cm x 1.4 cm LM393 wide voltage comparator Operating Current of 15mA Also has LEDs indicating…
- Add to cart
-
- Sensors
Tilt Vibration Sensor Module Vibration Switch Alarm Module
- KSh 150.00
- Tilt Vibration Sensor Module is a device used for knowing the planar movement. That means it detects the plane shift from horizontal to vertical then sends a signal when it happens.
- Add to cart
-
- Electronic components, Sensors
Ultrasonic Sensor Module HCSR04
- KSh 250.00
- Features of Ultrasonic Sensor Module HC-SR04 includes; Has a voltage of 5V DC It has a current of 15mA Frequency of 50Hz Resolution of 0.3 cm Lastly, it has a measuring angle of 15 degrees
- Add to cart
-
- Voltage sensor
Voltage Sensor Module for Voltage Detection
- KSh 200.00
- Features of Voltage Sensor Module includes; It has an Input Voltage of 0 to 25V Has a Voltage Detection Range of 0.02445 to 25 An Analog Voltage Resolution of 0.00489V In addition to that, it needs no external components Also it is Easy to use with Microcontrollers To add on that, it is Small, cheap and easily available Output Interface…
- Add to cart
