“L293D expansion board for Arduino motor driver” has been added to your cart. View cart
-
- Arduino, Modules, Motors
L293D expansion board for Arduino motor driver
- KSh 1,000.00
- L293D expansion board for Arduino has the L293D chips. L293D chip is a 4 channel driver. Features includes; Can drive 4 DC motors Up to 2 stepper motors or 2 Servo 4 bi-directional DC motors with individual 8-bit speed selection 4 H-Bridges Pull down resistors A reset button
- Add to cart
-
- Arduino, Electronic components, Wire
Male to Female jumper wires 20 cm long
- KSh 180.00
- These are male to female jumper wires that are 20 cm long. In addition to that, this package consists of 40 strands of wires. Each set is 4 times repeated as a single color.
- Add to cart
-
- Out of Stock
- Arduino, Electronic components
MAX7219 LED dot Matrix 8×8 module common cathode
- KSh 250.00
- MAX7219 LED dot Matrix module is very easy to use. In addition, it is compatible with a number of microcontrollers including Arduino. The micro-controllers can be connected to this module using the 4-wire serial interface. Moreover, it only needs three i/o data lines, and two power lines to drive. .
- Read more
-
-
- Out of Stock
- Actuators, Arduino, Electronic components
MG90 metal Gear Microservo Motor
- KSh 400.00
- Features of MG90 metal Gear Microservo includes; Has an Operating Speed of 0.1 s/60 degree (4.8 V), 0.08 s/60 degree (6 V) Has a Stall torque of 1.8 kgf·cm (4.8V ), 2.2 kgf·cm (6 V) Operates at a Temperature Range of -30° to +60° Operating Voltage of 4.8 V -6.0 V Also has metal Gears In addition, it has a dead…
- Read more
-
-
- Arduino, Development Boards, Modules, Programmers
NodeMCU ESP8266 v3 CH340 Lua WIFI Board
- KSh 800.00
- NodeMCU is an open-source Lua based firmware and development Board specially targeted for IoT based Applications. It includes firmware that runs on the ESP8266 Wi-Fi SoC Systems, and hardware which is based on the ESP-12 module. The Board can be easily programmed with Arduino IDE since it is easy to use.
- Add to cart
-
- Arduino
OV7670 Camera Module For Arduino
- KSh 500.00
- Features of OV7670 Camera Module For Arduino It has a High sensitivity for low light operation It has a Low Operating voltage Has an Optical size of 1/6 inch Resolution 640*480 VGA Additionally, it has an On board Regulator Lens shading correction Flicker(50/60Hz) auto detection Standard 0.1 inch (2.54mm) pin pitch header connector It Supports image sizes of VGA, CIF,…
- Add to cart
-
- Arduino, Electronic components, Sensors
Piezoelectric active Buzzer beep sounder for alarm
- KSh 30.00
- Piezoelectric active buzzer adds sound features to your project. It can be easily used on breadboard, Perf Board and even on PCBs. It widely used in electronics. When powered, it will make a beep sound. The sound is due to the internal oscillating circuit inside it.
- Add to cart
-
- Arduino
Pro Mini ATMEGA328P 16 MHz 5V for Arduino
- KSh 750.00
- Features 1. 14 digital input/output port RX and TX, D2 ~ D13, 2. 8 analog input port A0 ~ A7 3. 1 to the TTL level a serial port to send and receive port RX/TX 4.6 a PWM port, D3, D5, D6, D9, D10, D11 5. Using Atmel Atmega328P - AU microcontroller 6. Support serial download 7. Support external 3.3…
- Add to cart
-
- Arduino, Electronic components, Sensors
RFID Module 13.56MHz RC522 for Arduino
- KSh 500.00
- Features of RFID Module 13.56MHz RC522 includes; MFRC522 chip based board Operating frequency of 13.56MHz Supply Voltage of 3.3V Current of 13-26mA Read Range of 3 cm SPI Interface Moreover, has a max data transfer rate of 10Mbit / s Lastly, it has dimensions of 60mm × 39mm
- Add to cart
-
- Arduino, Modules
Sensor Shield expansion board for arduino
- KSh 500.00
- Features; Ad hoc IIC interface Has a stack design Both analog and digital Interface It has a Servo Controller Interface The sensor has a Bluetooth Module A communication interface SD card module interface module Also has an APC220 RF Module interface Moreover, it has an ultrasonic sensors Interface Lastly, has a 12864 LCD Serial interface
- Add to cart
-
- Actuators, Arduino, Electronic components
SG90 Plastic Gear Microservo Motor
- KSh 350.00
- Features of SG90 Plastic Gear Microservo includes; Has an Operating Speed of (4.8V no load) at 0.12 seconds / 60 degrees (4.8V) Has a Stall Torque of 1.6 kg / cm (4.8V) Operates at a Temperature Range of -30° to +60° Operating Voltage of 3.0-7.2 Volts Also has Plastic Gears In addition, it has a dead band width of 10…
- Add to cart
-
- Out of Stock
- Arduino, Humidity Sensor, Moisture sensors, Sensors
Soil Moisture Sensor for Arduino Board
- KSh 150.00
- Soil Moisture Sensor is used to measure the soil moisture gain or loss over a period of time. It depends on the permittivity of the surrounding medium to determine the moisture content. In addition, it automates the irrigation systems.
- Read more
-
