-
- Moisture sensors, Sensors
Rain Drop Sensor module for Arduino
- KSh 100.00
- Rain drop sensor module is used for rain detection. It can also be used as a switch when raindrop falls through the raining board.
- Add to cart
-
- Out of Stock
- Programmers, Raspberry Pi
Raspberry pi Case for Raspberry Pi B and B+
- KSh 500.00
- Raspberry pi Case provides the protective housing for you Pi board.
- Read more
-
-
- Raspberry Pi
Raspberry Pi Heat Sinks 3 pieces Heat dissipator
- KSh 150.00
- 74HC05 is a high-speed Si-gate CMOS device. It contains six inverters. The device has also outputs that are open-drain. Therefore, can be connected to other open-drain outputs to implement active-LOW wired-OR or active-HIGH wired-AND functions. 74HC05 suitable for use in automotive applications.
- Add to cart
-
- Out of Stock
- Uncategorized
Raspberry Pi Power Adapter 5V 3A
- KSh 2,000.00
- Raspberry pi Power Adapter. Convenient to power your Pi board and provides a constant current of 3 A.
- Read more
-
-
- Electronic components, LEDs
Red diffused LED 5mm Light Emitting Diode
- KSh 5.00
- Red diffused LED 5mm is a two-lead semiconductor light source. It emits lights when activated.
- Add to cart
-
- Modules
Relay Module 1 channel interface Shield
- KSh 150.00
- This Relay Module is 1 channel interface. It complies with the international safety standards. The module can control 220V AC load. It has a normally open and a normally closed contact. The KF301 terminals to the line of control is more convenient.
- Add to cart
-
- Out of Stock
- Arduino, Electronic components, Sensors
RFID Module 13.56MHz RC522 for Arduino
- KSh 500.00
- Features of RFID Module 13.56MHz RC522 includes; MFRC522 chip based board Operating frequency of 13.56MHz Supply Voltage of 3.3V Current of 13-26mA Read Range of 3 cm SPI Interface Moreover, has a max data transfer rate of 10Mbit / s Lastly, it has dimensions of 60mm × 39mm
- Read more
-
-
- Electronic components, Potentiometers
RM065 Trimpot Potentiometer 500Ω (501)
- KSh 10.00
- RM065 Trimpot Potentiometer is a variable resistor. It is small sized as well as light weight.
- Add to cart
-
- Modules, Potentiometers
Rotary Encoder Module for Arduino Incremental
- KSh 100.00
- Rotary Encoder Module is used to measure the rotational speed. It converts the angular motion of a shaft to digital code. Also used for quick speed control with PWM technology. An incremental rotary encoder outputs the corresponding pulses. Hence supports multiple circles of rotation measured. It differs from potentiometer in that the counting is unrestricted.
- Add to cart